Replacing the water inlet valve fixed my problem.
Lg washer detergent dispenser fills with water.
The bleach is separate on my washer from the detergent and fabric softener.
The spray may cause enough water to fill the dispenser tray but not enough to start the siphon.
The liquid soap dispenser drawer tray is filled with water after wash cycle is done.
The bleach dispenser fills with water but then gets sucked back out.
In this video i m showing y.
There are no visible clogs or blockages.
Not residual water as in normal but water up to the max line in later loads water remained in the softener dispenser but not in the soap tray as in the first time.
I am experiencing the same problem.
I had this issue of water soap overflowing and leaking out of the dispenser.
Wipe any moisture with a dry towel or cloth after cleaning.
I have an lg washer the 3570 and i do get water in the detergent dispenser cup but nothing like that.
Washer initially flushes detergent area left side and fills for wash cycle w o problem.
Pull the dispenser drawer towards you until it stops.
I ve removed the entire drawer tray and cleaned it out.
Pull the dispenser drawer towards you until it stops.
Hold the dispenser level and note how much water is left when the siphon is lost.
If one opens the dispenser in the middle of a cycle then yes you will find water like that in the cup.
While pressing down on the tab mentioned above pull the drawer toward you.
With drawer pulled out after initial fill and wash water enters back of dispenser in a trickle for rinsing never flowing through top right roof section of cavity through holes to drop into fabric softener well.
You can prove this at the sink.
It will still leave some residual.
Valve assembly should fix this.
I traced the issue down to the liquid detergent cup.
The washer runs water into that part and the prewash part of the dispenser all the time at least mine does.
If it does this then the problem might be a spray from the dispenser in following loads.
I just replaced it right now and watched the cycle for a few minutes.
Press down hard on the disengage button and pull out the detergent dispenser drawer.
Well it could be just splashing in there from the rinse water or the valve could be cracking open when the rinse water is being released causing it to fill a bit.
The detergent tray will completely remove from the front of the washer.
Clean each component with warm water and a soft bristled brush.
Soap dispenser is filled with water after each cycle.
With the drawer removed each compartment piece can be removed.
I bought the washer 3700hva on jan 29th and there was water in the liquid soap dispenser after the first load.
Press down on the depressed tab between the softener and bleach inserts.